Hallo mensen,
Ik heb een vraagje,
ik heb me vandaag een yoshimura RS-2 aangeschaft voor mijn LTZ
Nu las ik bij de instructie's dat je de thermostaat omdraaien maar dat gaat niet of moest verwijderen
nu vraag ik me af waarom? want als je gaat rijden en je rijd rustig kan de motor toch nooit op temperatuur komen.Zou het kwaad kunnen als ik hem gewoon laat zitten.
alleen ja het staat er natuurlijk niet voor niets,maar op de doos staat wel voor circuit gebruik hebben meer mensen dit gedaan of net niet gedaan
Gr Nigel
LTZ 400 Yoshimura RS-2
-
- Toeschouwer
- Berichten: 3
- Lid geworden op: di 03 feb, 2015 23:22
- Jason McCoy
- Quad GOD
- Berichten: 8394
- Lid geworden op: zo 24 jul, 2011 18:25
- Locatie: Lunteren
Re: LTZ 400 Yoshimura RS-2
Je thermostaat? Weet je dat zeker dat dat er staat want dat heeft echt niks met tuning te maken en mag je dus zeker niet verwijderen
Can-Am Renegade
Quad Team Gelderland
Quad Team Gelderland
-
- Toeschouwer
- Berichten: 3
- Lid geworden op: di 03 feb, 2015 23:22
Re: LTZ 400 Yoshimura RS-2
Ik heb een deel van de instructie's even gepost
12 Reinstall radiator hose and clamp.
13 THERMOSTAT COVER INSTALLATION (2003-08 Models)
• Install the thermostat in the reverse order of removal.
• Apply engine coolant to the rubber seal on the thermostat
14 Fill radiator with new coolant.
15 Refer to factory service manual for steps on bleeding
the cooling system.
16 Reinstall radiator cap.
17 It is recommended that the entire exhaust system be
wiped down with rubbing alcohol to remove oil and
fingerprints. This will help prevent tarnishing of the
finish after the exhaust is heated up.
18 Before starting motorcycle check for proper clearance
between new exhaust system and motorcycle. (i.e.
radiator & fan assembly, rear brake, frame, tire, etc.)
If any problem is found, please carefully follow
through the installation steps again. If problem still
persists, please call Yoshimura tech. Dept. At (800)634-
9166 / in CA (909)628-4722
12 Reinstall radiator hose and clamp.
13 THERMOSTAT COVER INSTALLATION (2003-08 Models)
• Install the thermostat in the reverse order of removal.
• Apply engine coolant to the rubber seal on the thermostat
14 Fill radiator with new coolant.
15 Refer to factory service manual for steps on bleeding
the cooling system.
16 Reinstall radiator cap.
17 It is recommended that the entire exhaust system be
wiped down with rubbing alcohol to remove oil and
fingerprints. This will help prevent tarnishing of the
finish after the exhaust is heated up.
18 Before starting motorcycle check for proper clearance
between new exhaust system and motorcycle. (i.e.
radiator & fan assembly, rear brake, frame, tire, etc.)
If any problem is found, please carefully follow
through the installation steps again. If problem still
persists, please call Yoshimura tech. Dept. At (800)634-
9166 / in CA (909)628-4722
Re: LTZ 400 Yoshimura RS-2
Er staat niet dat je de thermostaat moet verwijderen maar dat je hem moet installeren als op de wijze je hem er af hebt gehaald.
Je hebt hem er 123 af gehaald en dan moet je hem 321 (reverse order of removal) installeren.
Je hebt hem er 123 af gehaald en dan moet je hem 321 (reverse order of removal) installeren.
_____________________________
- Jason McCoy
- Quad GOD
- Berichten: 8394
- Lid geworden op: zo 24 jul, 2011 18:25
- Locatie: Lunteren
-
- Toeschouwer
- Berichten: 3
- Lid geworden op: di 03 feb, 2015 23:22
Re: LTZ 400 Yoshimura RS-2
Inderdaad nu je het zegt hahaha
excuses voor mijn lompheid maar ik twijfelde zo denk doe het toch maar eens vragen
excuses voor mijn lompheid maar ik twijfelde zo denk doe het toch maar eens vragen